18" Stainless Steel Drawer Slide, 38 Mm, 75Lb

Other products by Sugatsune
Item #: ESR-3813-18
Reg. Price: $30.00
Web Price: $25.50 Pair
20 in stock.
Usually Ships in 1-2 days.
Additional quantities usually ships in
1-4 weeks
Drawer Slides
  • buy at least 100, save 15%
  • buy 20 to 99, save 10%
  • buy 10 to 19, save 5%


The Sugatsune ESR-3813-18 is a 18 inch full extension stainless drawer slide. The 304 grade stainless drawer slides are ideal for use in damp, corrosive, coastal and marine applications such as boats, beach houses, laboratories, locker rooms, etc.
Unit of Measure
  • 304 grade stainless steel
  • Full Extension
  • Front Disconnect
  • Hold-in Detent
  • Non-Handed
  • Price is per pair
  • Screws NOT included
  • Use #8 pan head screws or similar
  • Extension
    Full Extension
    Side Mount
    Installation width
    12.2 mm (0.48")
    38 mm (1-1/2")
    Closed Length
    450 mm (17-23/32")
    457 mm (18")
    More Help
    Email Support


    Average Rating:
    (based on 1 review)

    Showing 1 Review:

    by Frank
    on 6/15/2016
    from Delaware
    good quality- difficult to install
    As I said in my rating on the same slide in the 20" length, this is a quality product. The 304 stainless steel is slightly magnetic. This is either because of poor quality SS or due to the fact that 304 SS can become slightly magnetic when worked (in this case probably cold rolled). My only complaint is that there is no screw slot that allows for up and down adjustment when installing the box side (larger piece) of the slide. You MUST get these dead on square and level the first try. In my case, putting them on a boat, and with no room to use the Rockler jig for this, it was a real challenge. (I am a professional woodworker and have installed hundreds of slides) On a positive note, they are a little forgiving when it comes to the width of your case. Mine was 1/16" larger than it should have been, but the slides still work smoothly after installation.

    OVIS Respose: These are cold rolled. 304 Stainless will be slightly magnetic, 316 less so, but it is too brittle to cold roll into a drawer slide.
    Review and Rate this Item

    Customer Testimonials