Hinge parts are mounted separately in bottom panel and flap, enabling subsequent flap assembly. Flaps are aligned through independent height, side and depth adjustment. Identical hole dimensions in bottom panel and flap. Three screw fasteners ensure firm and exact hinge seating in bottom panel and flap. Hole edge break-out is hidden by covering lip. In open position, inside face edges of bottom panel and flap are flush before height adjustment.
- Requires 2, 35mm diameter holes 12.1 mm deep. See specifications sheet linked below for details
- Flap hinge for overlay flaps
- Quality classification under EN 15828, Level 2
- Separate installation of bottom panel and flap element
- Flap alignment through adjustment of height, sides and depth
- Same drilling sizes in bottom panel and flap elements
- Hole drilling concealed by rim on both parts
- Without height adjustment, bottom panel and flap are flush on the inside when open
- Can only be used in conjunction with flap stays
- Nickel plated die-cast zinc
|
Unit of Measure
|
Each
|
|---|---|
|
Whats Included
|
1 hinge with two leaves, no screws
|
|
Specification Sheet
|
Hettich Markant 11 Specifications
 |
|
Installation Instructions
|
Hettich Markant 11 Instructions
|
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Similar Products
Hinge parts are mounted separately in bottom panel and flap, enabling subsequent flap assembly. Flaps are aligned through independent height, side and depth adjustment. Identical hole dimensions in bottom panel and flap. Three screw fasteners ensure firm and exact hinge seating in bottom panel and flap. Hole edge break-out is hidden by covering lip. In open position, inside face edges of bottom panel and flap are flush before height adjustment.
- Flap hinge for overlay flaps
- Quality classification under EN 15828, Level 2
- Separate installation of bottom panel and flap element
- Flap alignment through adjustment of height, sides and depth
- Same drilling sizes in bottom panel and flap elements
- Hole drilling concealed by rim on both parts
- Without height adjustment, bottom panel and flap are flush on the inside when open
- Can only be used in conjunction with flap stays
- Nickel plated die-cast zinc
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.